Hi-Tek Supercoat Bullets
How fast can I push Hi-Tek coated bullets
There are so many variables with that question, the quality of the barrel and heat from repetive shots. In best conditions 2400 fps
Hi-Tek Supercoat Bullets greatly reduce the amount of smoke normally associated with cast wax bullets
Lead fouling of the bore is drastically reduced or in most cases, eliminated completely
Hi-Tek Supercoated bullets gives off no toxins or particulate matter when fired
The Hi-Tek coating is 100% non abrasive and contains no PTFE or Moly
Hi-Tek Supercoated bullets are completely safe to use in Glocks polygonal rifled barrels
No wax lube to gum up your loading dies, and they run smoothly in most bullet feeders
The Hi-Tek coating greatly minimizes your exposure to lead
The Hi-Tek coating provides cleaner air, cleaner hands, cleaner reloading equipment and cleaned guns
Load the coated bullets the same way you would a lead bullet, with lead data.
Be sure that you have enough flare on the case mouth when seating the bullet or the coating may be scraped off, causing performance issues.
Also be sure you are not over-crimping as this will cause accuracy and leading issues.
Dirty / leaded barrels can be attributed to powders with fast and or hot burn rates. So avoid fast/hot buring powders with our Hi-Tek coated bullets.
Alliant Sport Pistol is inexpensive, readily available example of a powder made specifically for coated bullets.
Powders with a slower burn rate than the top 15 listed on the burn rate chart is highly recomended.